Matrox NRG Redundant Power Supply Unit
Quick tech specs
- Pre-installed on a 1U rackmount shelf.
- Includes two redundant power modules (300W each).
- Power up to five Matrox appliances simultaneously.
- 10/100Base-T for remote monitoring and controlling via management software or web browser.
- Device status LEDs.
- Standard 1 RU, ½ rack width form factor.
- Hot swappable.
- GPIO port to signal error condition.
- Recessed rocker switch to turn the device on and off.
Know your gear
Pre-installed and rack mountable | Single density
One NRG redundant power supply unit comes pre-installed on a 1U rack shelf, which can also hold a second ½ width RU (Rack Unit) Matrox device. The shelf is designed to fit standard 19" (48.26 cm) racks.
Dual density
Two NRG redundant power supply units come pre-installed on a 1U rack shelf. The shelf is designed to fit standard 19" (48.26 cm) racks.
Full redundancy for up to 5 devices
Matrox NRG includes two field-replaceable redundant power supply modules of 300W each. If one of the power supply modules fails, the output load will be completely supported by the second power module. The modules deliver hot-swap functionality, so you can replace an individual power module without interrupting the 12 volt outputs of the NRG. Automatic load balancing ensures even usage of both power supplies and extends the life of each.
Device monitoring and control
Monitor the status and control the outputs of the power supply unit remotely over IP. Through a convenient password-protected and HTTPS encrypted web interface, you can turn individual 12V outputs on and off and monitor check the status of each power supply module. An independent GPIO can also be used to monitor power module failures. The device also features LEDs that provide the status of each 12V output and AC input.
Enhance your purchase
Better Together
This Item: Matrox NRG Redundant Power Supply Unit