Transition 3-port 10/100BASE-TX Redundant Link Protector

Mfg.Part: CBFTF1010-130 | CDW Part: 1262664 | UNSPSC: 43222622
  • 3-port 10/100BASE-TX (RJ-45) 100 m/328 ft. Redundant Link Protector
View Full

This item was discontinued on May 01, 2018

Contact Sales Assistance
(800) 800-4239, Monday-Friday 7am-7:30pm CT

Email our Sales Assistance Team , Response within 24 Hours

Better Together
Quick View
Total Price:

Product Overview

Main Features
  • 3-port 10/100BASE-TX (RJ-45) 100 m/328 ft. Redundant Link Protector
The Redundant Link Protector is a 10/100 Ethernet fault-tolerant transceiver. It significantly reduces network downtime, adding a new level of redundancy to 10/100 Ethernet connections. It also provides a redundant path for critical 10/100 devices.In a 10/100 Ethernet network, a critical device such as a file server may be connected to the rest of the network through a hub or a switch. A common problem in this configuration is that the server is often connected to the network through a single cable. If the cable fails, then the server is disconnected from the rest of the network. Similarly, if a port of a hub or switch to which the server is connected fails, the server is disconnected from the network.

The Redundant Transceiver has three ports: one for the critical (main) device, one for the default (primary) path for the critical device, and another (backup) for the backup path. It is a smart device that will not send any signal on a path that is not active. If the primary path loses its link, then the transceiver will immediately (in less than one microsecond) switch to the backup path.

When the primary path re-establishes its link, the Redundant Link Protector will automatically switch back to the primary path.

Optional functionality, controlled via a dip switch, allows the unit to move from the fault-tolerant mode to a 3-port switch mode.

Features:

Fault-tolerant redundant connections

Easy to install and use

Supports half and full-duplex transmission

AutoCross™ (on all 3 ports):
Automatically detects and configures the twisted pair port on the converter to the correct MDI or MDI-X configuration.

Auto-Negotiation (802.3u):
Allows devices to perform automatic configuration to achieve the best possible mode of operation over a link.

IEEE 802.3 compliant

Nine diagnostic LEDs

Optional 3-port switch mode

Point System™ Chassis:
Can be used with any Point System™ Chassis.

The following management features are available when the converter is used in a managed Point System™ Chassis:

Read Management features:
Media Converter Power
Copper Link Status
Copper Port Speed
Duplex Mode
Hardware Switch Settings

Write Management features:
Power on/off device
Enable Redundancy / 3-port Switch mode

Individual Port Control:
Enable/disable Auto-Negotiation
Force Full or Half Duplex
Force 10Mbps or 100Mbps